Installation and Configuration
Other IPDS Menu Selections
OCRB Font Density and Early Print Complete are not accessed under the IPDS
menu selections but are accessed from other menu selections.
OCRB Font Density
OCRB Font Density is accessed under Printer Control menu selections and
determines the print quality for OCRB character sets:
120 (Default) Vertical is 120; horizontal is 144
180 Vertical is 180; horizontal is 144
Note: The higher the resolution you select, the slower the print speed. So when
selecting a resolution, try to balance the resolution quality your application
requires with how fast you want the print job to print.
Early Print Complete
Early Print Complete is accessed under Twinax Interface menu selections. The
value described below only applies to IPDS and Twinax; this does not apply to
Early Print Complete under Coax Interface, which is a separate function. Early
Print Complete is used to determine when the next print job can be sent to the
printer. Do not select Early Print Complete while a print job is in process. If you
do, you will need to restart the printer.
Dis able (De fa ult) Disable means that the printer waits for the system or
controller to finish a job before issuing a print complete
status. The spool file is not released until printing is
completed. This can cause the printer to print at less than
rated speed but can help ensure that all data is printed.
Enable Enable means that the printer does not wait for the system
or controller to finish a job before issuing a print complete
status. The spool file can be deleted before printing is
completed. This can cause the printer to print at rated
speed but some data, particularly the last few lines, of the
last print job may be lost.
22 6400 IPDS
To Next Page
Loading...
Need help?
General