Installation and Configuration
Chapter 2. System Configuration
The following information provides information useful in attaching and
configuring this printer when the IDPS feature is installed. There are three basic
steps you need to complete:
1. Configure your host system for the printer.
2. Configure applicable host software, such as PSF/MVS.
3. Configure the printer to match host system settings.
Each of the above steps is described in this section. Also, you will need access
to information about your host system and applicable host applications. Where
appropriate, references are made to a host documentation you will need to
review. For instance, you will need a copy of the PSF/MVS Systems
Programming Guide, S544-3672, when configuring PSF/MVS and this printer.
If you are not familiar with physical and logical unit types, review “Summary of
Physical and Logical Unit Types” on page 16 for descriptions of commonly used
physical and logical units.
Note: Throughout the following examples, this printer is referred to as the 6400.
Ó Copyright IBM Corp. 1995 9
To Next Page
Loading...
Need help?
General