103
8
MEMORY OPERATION
q Push [PBT/M-ch/RIT] momentarily to select the M-
ch/RIT function, if the twin PBT is selected.
•[PBT/M-ch/RIT] indicator (Green) goes out.
w Set the desired frequency and operating mode in
VFO mode.
•If you want to program the split frequency function, pro-
gram both receive and transmit frequencies into VFO
A and B, then turn ON the split function. (p. 91)
•If you want to program a repeater function, set a tone
frequency (p. 60) in addition to the receive/transmit fre-
quencies.
e Select the menu
M
-
2
.
r Push [F-1
MEM
] to display the memory channel
contents.
•Memory channel contents appear above the multi-func-
tion key indicator.
•Push [F-1
LST
] to display the memory channel list.
This is convenient for selecting the desired channel.
Push [
Z
(
MENU
/
GRP
)] to exit the memory channel list.
t Rotate [M-ch] to select the desired memory chan-
nel.
•“ ” and “---,---,--” appear if the selected memory
channel is a blank channel (and does not have con-
tents).
•Rotating [RIT] (outer) control changes the bank.
y Push [F-2
MW
] for 1 sec. to program the displayed
frequency and operating mode into the selected
memory channel.
To check the programmed contents, push [F-4
V/M
]
to select memory mode.
■ Memory programming
D Programming in VFO mode
Memory channel programming can be performed ei-
ther in VFO mode or in memory mode.
Menu group selection
Push [MENU/GRP] for 1 sec.
Selection from:
M
,
S
or
G
(Graphic)
Menu selection (Example: M)
Push [MENU/GRP] momentarily.
Selection from:
M
-
1
,
M
-
2
or
M
-
3
To Next Page
Loading...
Need help?
General
Weight and Dimensions
