Icom IC-7000 Instruction Manual

135
13
SET MODE
■ Miscellaneous (others) set mode (continued)
30
HM-151 [F-1]
This item programmes for one of several functions to
[F-1] key of HM-151. Programmable key assignments
are described as below.
MPW
Memo pad write is pro-
grammed. (default)
ANF
Auto notch filter is pro-
grammed.
31
HM-151 [F-2]
This item programmes for one of several functions to
[F-2] key of HM-151. Programmable key assignments
are same as above.
MPR
Memo pad read is pro-
grammed. (default)
NB
Noise blanker function is
programmed.
34
SSB/CW Synchronous Tuning
This item selects the displayed frequency shift func-
tion from ON and OFF.
When this function is activate, the receiving signal
can be kept to receive even when the operating mode
is changed between SSB and CW.
The frequency shifting value may differ according
to the CW pitch setting.
ON
The displayed frequency
shifts when the operating
mode is changed between
SSB and CW.
OFF
The displayed frequency
does not shift.
(default)
32
MIC Up/Down Speed
This item sets the rate at which frequencies are
scanned when the microphone (HM-151) [
Y
]/[
Z
]
keys are pushed and held. High or low can be se-
lected.
HIGH
High speed (default,
50 tuning steps/sec.)
LOW
Low speed
(25 tuning steps/sec.)
33
Quick RIT/∂TX Clear
This item selects the RIT/∂TX frequency clearing in-
struction with [F-3
CLR
] key.
See pgs. 75, 88 for deatails.
ON
Clears the RIT/∂TX fre-
quency when [F-3
CLR
] is
pushed momentarily.
OFF
Clears the RIT/∂TX fre-
quency when [F-3
CLR
] is
pushed and held for 1 sec.
(default)
“P.AMP/ATT” (Preamplifier/attenuator),
“NB” (Noise blanker),
“NR” (Noise reduction),
“MNF” (Manual notch filter),
“ANF” (Auto notch filter),
“TS” (Tuning step),
“SPL” (Split operation),
“A/B” (VCO A/B selection),
“MCL” (Memory clear),
“BNK” (Bank selection),
“COM” (Speech compressor),
“AGC” (AGC selection),
“TBW” (TX filter width),
“DUP” (Duplexer),
“TON” (FM tone operation),
“MET” (Meter selection),
“VSC” (Voice squelch control),
“MPW” (Memo pad write),
“MPR” (Memo pad read),
“<SCOPE>” (Scope selection),
“<METER>” (Multi-meter selection)

Icom IC-7000 Specifications

General

Input voltage	13.8 V
Microphone included	Yes
Product type	Portable CB radio
Product color	Black
Housing material	-
Frequency range	0.5 - 455000 MHz
Channels quantity	503 channels

Weight and Dimensions

Depth	180 mm
Width	167 mm
Height	58 mm