56
4
RECEIVE AND TRANSMIT
4
D Pre-setting for using RTTY terminal or TNC
When using your RTTY terminal or TNC, consult the
manual that comes with the RTTY terminal or TNC.
Mark frequency
q Push [MODE] momentarily to select RTTY mode.
•After RTTY mode is selected, push [MODE] for 1 sec.
to toggle between RTTY and RTTY-R modes.
w Push [AF(
SET
)] momentarily to enter the set mode
menu.
e Push [F-1
QS
] to enter the quick set mode.
r Push [F-1 Y] or [F-2 Z] to select “
RTTY Mark
Frequency
.”
t Rotate [DIAL] to select the desired frequency.
•Push [F-4
DEF
] for 1 sec. to select the default fre-
quency.
Shift width
q Enter the quick set mode as same as above.
w Push [F-1 Y] or [F-2 Z] to select “
RTTY Shift
Width
.”
e Rotate [DIAL] to select the desired shift width.
•Push [F-4
DEF
] for 1 sec. to select the default shift
width.
RTTY keying polarity
q Enter the quick set mode as same as above.
w Push [F-1 Y] or [F-2 Z] to select “
RTTY key-
ing Polarity
.”
e Rotate [DIAL] to select the desired keying polarity.
•Push [F-4
DEF
] for 1 sec. to select the default polarity.
After Pre-setting is finished, push [
Z
(
MENU
/
GRP
)] mo-
mentarily twice to return the normal operating mode.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
