Invacare Pronto M91 - Installing Side Rails

SECTION 4—SEAT
Part No. 1125038 55 Pronto
®
M91™and M94™
Installing Side Rails
1. Installnewsiderailsontocrossbars.
NOTE:Ensurelongendofsiderailistowardsthefrontofthewheelchair.
2. Securethesiderailstothecrossbarswiththehexscrews,washerandlanyard.Torque
to75in‐lbs±20%.
3. Slidecanebrackets(withT‐nutsandbackassembly)intotheslotsinthesiderails.
4. Slidefrontarmsockets(withT‐nuts)intotheslotsinthesiderails.
5. Usearubbermallettotapthetworollpinsintothesiderails.
6. Adjusttheseatdepth.RefertoAdjustingtheSeatDepth
onpage 52.
7. Tightenthefourhexscrewstosecurethecanebracketstothesiderails.Torqueto13
ft‐lbs±20%.
8. Installthearmrests.
NOTE:Itmaybenecessarytoslidethefrontarmsocketstotheproperpositiontoinstallthe
armrests.
9. Tightenthefourhexscrewstosecure
thefrontarmsocketstothesiderails.Torqueto
13ft‐lbs±20%.
FIGURE 4.14 Removing/Installing Side Rails
Side View
Hex Screws
Washer
Roll
Pin
Crossbar
Side Rail
Hex Screws
Front Arm
Socket
Cane Bracket
Slot
Back
Cane