Invacare Pronto M91 - Adjusting the Footboard Assembly; Angle

SECTION 7—FOOTBOARD ASSEMBLY
Part No. 1125038 79 Pronto
®
M91™and M94™
FIGURE 7.1 Removing/Installing the Footboard Assembly
Adjusting the Footboard Assembly
Angle
NOTE:Forthisprocedure,refertoFIGURE 7.2.
1. Loosenthejamnutandsetscrewlocatedunderneaththerearofthefootplate.
2. Adjustthesetscrewinorouttoobtainthedesiredfootboardassemblyangle.
3. Threadthejamnutandwasherinwarduntilflushwiththefootboardbracket.
4. Securelytightenthejamnutandwashertosecurethemountingscrewinplace.
FIGURE 7.2 Adjusting the Footboard Assembly - Angle
DETAIL “A” - Bottom View of
Footboard
Quick Release Pin
Outer Edge of Tube
Detent Balls
Quick
Release
Pin
Wheelchair Frame
Detent Ball
Footboard Assembly
Mounting
Hole
Set Screw, Washer and Jam Nut
Footboard Assembly