TYPICAL PAGE - B
Section Title
Cable, Hose, and Wire Rou mg
Route
all
hoses, control cables, and wiring
through a protective
sleeve or conduit into
the
boat and through the grommet.
Refer
to
the
following diagram to ensure proper
positioning of rigging components
in
grommet.
1. Fuel supply hose
2.
Oil return hose
3. Oil supply hose
4. Battery cables
5. Main wire harness
(MWS)
6.
Throttle cable
7.
Shift cable
8.
Oil tank sending unit harness
9. Water pressure hose
10
. Accessory charge wire
Model specific
illustrations
designated with
image captions
000084
Connect outboard main wire harness to boat m
wire harness.
Before
installing electrical connectors, check tha
the
seal
is
in
place. Clean off dirt from con-
nectors. Apply a light coat of
~~!!!I!!
to
the
seal.
Push
connec~rs
latched.
1. Seal
INTRODUCTION
TYPICAL PAGE - B
a water pressure gauge
is
to
be
used, install the
water pressure hose fitting
in
the cylinder block.
Use Pipe Sealant with Teflon
(PIN
910048)
on
the
threads of the hose fitting. Refer to installation
instructions
supplied with gauge.
Route the water pressure hose through cover
grommet with
oil
tank sending unit harness. Route
hose
along battery cables toward the back of
the
powerhead. Use tie straps to fasten
in
place.
pressure fitting location:
top
, starboard side
of
cylinder/crankcase assembly, below throttle
position
sensor.
If temperature gauge
is
to
be
used,
route
sending
unit wire through grommet
with
hose for water
pressure gauge.
Follow the
path
of battery cables.
Provide adequate length
to
reach
cylinder head.
Refer to installation instructions
supplied
with
gauge.
47
I
9
E
o
U
Qj
)(
~
Qj
~
ii
E
To Next Page
Loading...
Need help?
General
