INTRODUCTION
TYPICAL PAGE - C
TYPICAL PAGE - C
10
POWERHEAD
INSTALLATION
motor mount, washer, and
sll~lc:ed
as
an
assembly. Do not disas-
39820
Installation
Place mount assemblies
in
position, with flats fac-
ing away from each other.
49557
Apply Extreme Pressure Grease to all sides of
retainer and
install between mounts.
Apply
Nut
Lock
to
retainer screw, install the screw,
and torque
to
15
to 20
ft
. Ibs. (20 to 27 N·m).
1. Mount retainer screw
272
a procedure
concerning a
particular model
Title
indicates the
mstex
procedure specific to inner
V4 Models is
finished. From this
from this
pOint,
All Models
a
new
are concerned ensure
proper
sealing, clean
and free of oil, grease, and foreign matter.
23497
Coat the driveshaft splines with Moly Lube.
Do
not
apply lubricant to end of driveshaft.
E
o
o
~
><
~
Qj
~
i:i
E
To Next Page
Loading...
Need help?
General
