Configuring the LCD Panel on EX Series Switches (CLI Procedure)
This topic applies to hardware devices in the EX Series product family, which includes
switches and the XRE200 External Routing Engine, that support the LCD panel interface.
The LCD panel on the front panel of EX Series switches displays a variety of information
about the switch in the Status menu and provides the Maintenance menu to enable you
to perform basic operations such as initial setup and reboot. You can disable these menus
or individual menu options if you do not want switch users to use them. You can also set
a custom message that will be displayed on the panel.
This topic describes:
•
Disabling or Enabling Menus and Menu Options on the LCD Panel on page 173
•
Configuring a Custom Display Message on page 174
Disabling or Enabling Menus and Menu Options on the LCD Panel
By default, the Maintenance menu, the Status menu, and the options in those menus in
the LCD panel are enabled. Users can configure and troubleshoot the switch by using
the Maintenance menu and view certain details about the switch by using the Status
menu.
If you do not want users to be able to use those menus or some of the menu options, you
can disable the menus or individual menu options. You can reenable the menus or menu
options.
Issue the show chassis lcd menu operational mode command to see the menus or menu
options that are currently enabled.
NOTE: On some platforms, you must specify an FPC slot number in these
commands. See the lcd-menu statement for details.
To disable a menu:
[edit]
user@switch# set chassis lcd-menu menu-item menu-name disable
To enable a menu:
[edit]
user@switch# delete chassis lcd-menu menu-item menu-name disable
To disable a menu option:
[edit]
user@switch# set chassis lcd-menu menu-item menu-option disable
173Copyright © 2017, Juniper Networks, Inc.
Chapter 15: Performing Initial Configuration
To Next Page
Loading...
Need help?
General