Figure 58: Installing an Uplink Module in an EX4200 Switch
NOTE: If you have a Juniper J-Care service contract, register any addition,
change, or upgrade of hardware components at
https://www.juniper.net/customers/support/tools/updateinstallbase/ . Failure
to do so can result in significant delays if you need replacement parts. This
note does not apply if you replace existing components with the same type
of component.
Related
Documentation
Troubleshooting Virtual Chassis Port Connectivity on an EX4200 Switch on page 238•
• Removing an Uplink Module from an EX4200 Switch on page 189
• Installing a Transceiver on page 193
• Installing and Removing EX4200 Switch Hardware Components on page 140
• Configuring Gigabit Ethernet Interfaces (CLI Procedure)
• Front Panel of an EX4200 Switch on page 11
Removing an Uplink Module from an EX4200 Switch
If your EX4200 switch includes an optional uplink module, it is installed in the switch's
front panel. The different types of uplink modules are described in “Uplink Modules in
EX4200 Switches” on page 18.
Theuplink modulein EX4200 switches is a hot-removable and hot-insertable unit (FRU):
You can remove and replace it without powering off the switch.
189Copyright © 2017, Juniper Networks, Inc.
Chapter 18: Replacing Uplink Module
To Next Page
Loading...
Need help?
General