Related
Documentation
General Safety Guidelines and Warnings on page 243•
• General Electrical Safety Guidelines and Warnings on page 271
• Installation Instructions Warning on page 251
• Grounded Equipment Warning on page 258
Ramp Warning
WARNING: When installing the device, do not use a ramp inclined at more
than 10 degrees.
Waarschuwing Gebruik een oprijplaat niet onder een hoek van meer dan 10
graden.
Varoitus Älä käytä sellaista kaltevaa pintaa, jonkakaltevuus ylittää 10astetta.
Attention Ne pas utiliser une rampe dont l'inclinaison est supérieure à 10
degrés.
Warnung Keine Rampen mit einer Neigung von mehr als 10 Grad verwenden.
Avvertenza Non usare una rampa con pendenza superiore a 10 gradi.
Advarsel Bruk aldri en rampe som heller mer enn 10 grader.
Aviso Não utilize uma rampa com uma inclinação superior a 10 graus.
¡Atención! No usar una rampa inclinada más de 10 grados
Varning! Använd inte ramp med en lutning på mer än 10 grader.
Related
Documentation
General Safety Guidelines and Warnings on page 243•
• Installation Instructions Warning on page 251
• Grounded Equipment Warning on page 258
Rack-Mounting and Cabinet-Mounting Warnings
Ensure that the rack or cabinet in which the device is installed is evenly and securely
supported. Uneven mechanical loading could lead to a hazardous condition.
WARNING: To prevent bodily injury when mounting or servicing the device
in a rack, take the following precautions to ensure that the system remains
stable. The following directives help maintain your safety:
Copyright © 2017, Juniper Networks, Inc.254
EX4200 Switch Hardware Guide
To Next Page
Loading...
Need help?
General