CHAPTER 21
Replacing a Member Switch to Virtual
Chassis
•
Adding a New EX4200 Switch to an Existing EX4200 Virtual Chassis (CLI
Procedure) on page 203
•
Replacing a Member Switch of a Virtual Chassis Configuration (CLI
Procedure) on page 209
Adding a New EX4200 Switch to an Existing EX4200 Virtual Chassis (CLI Procedure)
This topic explains how to add an EX4200 switch to an existing EX4200 Virtual Chassis.
For information about adding an EX4200 switch to an EX4500 Virtual Chassis or a mixed
Virtual Chassis, see Adding an EX4200 Switch to a Preprovisioned EX4500 Virtual Chassis
or a Preprovisioned Mixed EX4200 and EX4500 Virtual Chassis (CLI Procedure).
To add an EX4200 switch to an existing EX4200 Virtual Chassis, use the procedure that
matches what you need to accomplish:
•
Adding a New Switch to an Existing Virtual Chassis Within the Same Wiring
Closet on page 203
•
Adding a New Switch from a Different Wiring Closet to an Existing Virtual
Chassis on page 205
•
Adding a New Switch to an Existing Preprovisioned Virtual Chassis Using
Autoprovisioning on page 207
Adding a New Switch to an Existing Virtual Chassis Within the Same Wiring Closet
This procedure can be used to add an EX4200 switch to an EX4200 Virtual Chassis.
Before you begin, be sure you have:
•
Mounted the new switch in a rack.
•
Confirmed that the new switch is powered off.
•
If you are expanding a preprovisioned configuration, made a note of the serial number
(the number is on the back of the switch). You will need to edit the Virtual Chassis
configuration to include the serial number of the new member switch.
203Copyright © 2017, Juniper Networks, Inc.
To Next Page
Loading...
Need help?
General