•
Status of the fan and temperature
•
Version of Junos OS for EX Series switches loaded on the switch
In the maintenance mode, the second line displays one of the following options that you
can use to configure and troubleshoot the switch:
•
System halt
•
System reboot
•
Load rescue
•
Request VC port (for an EX4200 switch that is a member of a Virtual Chassis)
•
Factory default
•
System EZSetup
LCD Panel Menus
The LCD panel has three menus: Idle, Status, and Maintenance. Toggle between the LCD
panel menus by pressing the Menu button. Navigate through the menu options by pressing
the Enter button.
Table 6 on page 15 describes the LCD panel menu options.
Table 6: LCD Panel Menu Options
DescriptionMenu
In the Idle menu:
•
Press Enter to cycle through the Status LED modes:
•
SPD (speed)
•
ADM (administrative status)
•
DPX (duplex)
•
POE (Power over Ethernet)
See Network Port LEDs in EX3200 Switches or “Network Port LEDs in EX4200 Switches” on page 24 for
information about the Status LED modes.
•
Press Menu to exit the Idle menu and go to the Status menu.
IDLE
15Copyright © 2017, Juniper Networks, Inc.
Chapter 2: Chassis Components and Descriptions
To Next Page
Loading...
Need help?
General