CAUTION: Do not stack any of the hardware components.
Packing MX5, MX10, MX40, and MX80 Routers for Shipment
To pack the router for shipment:
1. Retrieve the shipping box and packing materials in which the router was originally
shipped. If you do not have these materials, contact your Juniper Networks
representative about approved packaging materials.
2. On the console or other management device connected to the Routing Engine, enter
CLI operational mode and issue the following command to shut down the router
software.
user@host> request system halt
Wait until a message appears on the console confirming that the operating system
has halted.
For more information about the command, see the CLI Explorer.
3. Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
ESD points on the chassis.
4. Shut down power to the router by pressing the AC input switch or DC circuit breaker
for all power supplies to the off (O) position.
5. Disconnect power from the router.
6. Remove the cables that connect to all external devices.
7. Remove all field replaceable units (FRUs) from the router.
8. Remove the router from the rack. One person should grasp the router while a second
person unscrews and removes the mounting screws from the rack. One lifter can then
move the router to the shipping container.
9. Place the router in the shipping container.
10. Cover the router with an ESD bag and place the packing foam on top of and around
the router.
11. Replace the accessory box on top of the packing foam.
139Copyright © 2019, Juniper Networks, Inc.
Chapter 6: Contacting Customer Support and Returning the Chassis or Components
To Next Page
Loading...
Need help?
General
