•
Om denna enhet installeras på en delvis fylld ställning skall ställningen
fyllas nedifrån och upp, med de tyngstaenheterna längst ned på ställningen.
•
Om ställningen är förseddmed stabiliseringsdonskall dessa monterasfast
innan enheten installeras eller underhålls på ställningen.
Ramp Warning
WARNING: When installing the hardware equipment, do not use a ramp
inclined at more than 10 degrees.
Waarschuwing Gebruik een oprijplaat niet onder een hoek van meer dan 10
graden.
Varoitus Älä käytäsellaista kaltevaa pintaa, jonka kaltevuus ylittää 10 astetta.
Attention Ne pas utiliser une rampe dont l'inclinaison est supérieure à 10
degrés.
Warnung Keine Rampen mit einer Neigung von mehr als 10 Grad verwenden.
Avvertenza Non usare una rampa con pendenza superiore a 10 gradi.
Advarsel Bruk aldri en rampe som heller mer enn 10 grader.
Aviso Não utilize uma rampa com uma inclinação superior a 10 graus.
¡Atención! No usar una rampa inclinada más de 10 grados
Varning! Använd inte ramp med en lutning på mer än 10 grader.
Related
Documentation
General Safety Guidelines for Juniper Networks Devices on page 143•
• General Safety Warnings for Juniper Networks Devices on page 144
• Maintenance and Operational Safety Warnings for Juniper Networks Devices on page 158
General Laser Safety Guidelines for Juniper Networks Devices
Devices with single-mode optical interfaces are equipped with laser transmitters, which
are considered Class 1 Laser product by the U.S. Food and Drug Administration, and are
evaluated as a Class 1 Laser Product according to EN 60825–1 +A11 +A2 requirements.
When working around devices with optical interfaces, observe the following safety
guidelines to prevent eye injury:
•
Do not look into unterminated ports or at fibers that connect to unknown sources.
•
Do not examine unterminated optical ports with optical instruments.
Copyright © 2019, Juniper Networks, Inc.154
MX5, MX10, MX40, and MX80 Universal Routing Platforms Hardware Guide
To Next Page
Loading...
Need help?
General
