Juniper SRX110 Hardware Guide

CHAPTER 16
Monitoring the SRX110 Services Gateway
This chapter describes how to monitor the SRX110 Services Gateway hardware
components. If you encounter software problems, or problems with hardware components
not discussed here, contact the Juniper Networks Technical Assistance Center (JTAC).
This chapter includes the following topics:
•
Monitoring the Hardware Components on the SRX110 Services Gateway on page 97
•
Resetting the Configuration File When the SRX110 Services Gateway Is
Inaccessible on page 102
•
Juniper Networks Technical Assistance Center on page 103
Monitoring the Hardware Components on the SRX110 Services Gateway
This topic includes the following sections:
•
Monitoring the SRX110 Services Gateway Chassis Using the CLI on page 97
•
Monitoring the SRX110 Services Gateway Components Using LEDs on page 98
•
Monitoring the SRX110 Services Gateway Using Chassis Alarm Conditions on page 100
•
Monitoring the SRX110 Services Gateway Power System on page 101
Monitoring the SRX110 Services Gateway Chassis Using the CLI
You can monitor alarms to troubleshoot hardware problems on a services gateway. The
chassis properties include the status of active chassis alarms and environment
measurements on the device.
To view these chassis properties, select Monitor in the J-Web interface, or enter the
following CLI show commands:
•
show chassis hardware
•
show chassis hardware detail
•
show chassis environment
•
show chassis fpc
•
show chassis alarms
Examples
97Copyright © 2013, Juniper Networks, Inc.

Juniper SRX110 Specifications

General

Brand	Juniper
Model	SRX110
Category	Gateway
Language	English