Juniper SRX110 Hardware Guide

Table 27: SRX110 Services Gateway Preinstallation Checklist for
Desk-Mount Installation (continued)
Additional InformationTask
Verify that you have the following parts available in
your desk-mounting kit to mount the SRX110 Services
Gateway vertically:
•
Vertical stand
•
Screws
NOTE: If youare mounting the services gateway horizontallyon a desk,ensure
that the rubber feet are attached to the chassis.
NOTE: The vertical desk-mounting kit is not shipped with the device and
must be ordered separately.
Preparing the SRX110 Services Gateway for Wall-Mount Installation
You can mount an SRX110 Services Gateway on a wall. The four rubber feet attached to
the chassis provide stability.
Table 28 on page 55 provides the list of tasks you need to perform before installing the
device.
Table 28: SRX110 Services Gateway Preinstallation Checklist for
Wall-Mount Installation
Additional InformationTask
“Site Preparation Checklist for the
SRX110 Services Gateway” on page 37
Verify that the site meets the requirements.
“Unpacking the SRX110 Services
Gateway” on page 49
Remove the services gateway chassis from the
shipping carton.
Verify that you have the following parts available in
your wall-mounting kit to mount the SRX110 Services
Gateway on a wall:
•
Wall-mounting brackets
•
Screws
NOTE: The wall-mounting kit is not shipped with the device and must be
ordered separately.
55Copyright © 2013, Juniper Networks, Inc.
Chapter 9: Preparing the SRX110 Services Gateway for Installation

Juniper SRX110 Specifications

General

Brand	Juniper
Model	SRX110
Category	Gateway
Language	English