Juniper SRX110 Hardware Guide

Table 7: SRX110 Services Gateway Back Panel Components (continued)
ComponentNumber
Cable tie holder7
NOTE:
•
If there is any problem with the CompactFlash card, you must return the
services gateway for repair or replacement. For this, you need to contact
Juniper Networks Technical Assistance Center (JTAC).
•
The cable tie holder provides support for holding the power cord to the
power supply point.
•
The lock allows you to lock and secure the device to the installation site.
Related
Documentation
SRX110 Services Gateway Specifications on page 7•
• SRX110 Services Gateway Built-In Interfaces on page 11
• SRX110 Services Gateway LEDs on page 13
• SRX110 Services Gateway Power Supply on page 16
SRX110 Services Gateway Built-In Interfaces
Table 8 on page 11 summarizes the interface ports supported on the SRX110 Services
Gateway.
Table 8: SRX110 Services Gateway Built-In Hardware Interfaces
DescriptionSpecificationInterface
The Fast Ethernet ports can be
used:
•
To provide LAN connectivity
to hubs, switches, local
servers, and workstations.
•
To forward incoming data
packets to the device.
•
To receive outgoing data
packets from the device.
The Fast Ethernet ports:
•
Consist of eight fixed ports
•
Are labeled as port 0/0 to
port 0/7 on the front panel
•
Provide link speeds of
10/100 Mbps
•
Operate in full-duplex and
half-duplex modes
•
Support flow control
•
Support autonegotiation
•
Support autosensing
Fast Ethernet
11Copyright © 2013, Juniper Networks, Inc.
Chapter 2: SRX110 Services Gateway Hardware Components and Specifications

Juniper SRX110 Specifications

General

Brand	Juniper
Model	SRX110
Category	Gateway
Language	English