Single−axis controllers
Preparing the commissioning procedure
3
164
EDS94SPP101 EN 10.2
3.10 Preparing the commissioning procedure
You need the following for commissioning:
ƒ Keypad EZAEBK0001
or
ƒ Computer with Windows® operating system (XP or 2000)
ƒ Lenze PC software »Engineer«
ƒ Connection with the controller via an interface, e.g.
– Diagnostic interface X6 with USB diagnostic adapter
– System bus (CANopen)
– Communication module
ƒ Software manual for the technology application used
ƒ The communication manual for the network of the automation platform
ƒ Mains voltage or 24−V voltage supply for the control electronics of the controller
Follow the instructions of the software and/or read the documentation.
To Next Page
Loading...
Need help?
General