Manitowoc Grove TMS9000-2 Series User Manual

GROVE 6-79
TMS9000-2 OPERATOR MANUAL SET-UP AND INSTALLATION
6
Published 02-21-2019, Control # 611-05
Extension Hydraulic Connection
All hydraulic lines are located in the 26 ft (8 m) extension
(Figure 6-162). The hose lines are installed so that short
ends are located to the rear and long ends to the front of the
extension.
The long ends (1) of the hoses are suspended from clamps.
The short ends (2) of the hoses are positioned at the rear of
the lower cross-strut.
NOTE: Connecting the hydraulic lines from the boom nose
to the hydraulic luffing boom extension through the
26 ft (8 m) and 20 ft (6 m) inserts are the same as
connecting to the 26 ft (8 m) insert only.
Connecting Main Boom Hydraulics
1. If necessary, install the hydraulic hoses (1)
(Figure 6-163) on the boom nose, refer to Extension
Hydraulic Connections (Optional Hydraulic Extension),
page 6-58.
2. Route the short ends (2) to the main boom head.
3. Remove the protective caps and connect the short ends
(2) to the boom nose connectors (1).
Disconnecting Main Boom Hydraulics
1. Disconnect the short hose ends (2) from the boom nose
connectors (1) (Figure 6-163).
2. Cover the short end and boom nose connectors with the
protective caps.
3. Route the short ends (2) inside and place them in front of
the lower cross-strut so that they do not hang down.
Connecting the Folding Extension Hydraulics
1. Remove the long hose (1) (Figure 6-164) from the
holders (2) on the insert.
2. Route the hoses to the front of the insert.
3. Remove the protective caps and connect the folding
extensions hoses (3) to the long hose ends (4).
6
FIGURE 6-161
2
1
3
4
5
7
8
2
FIGURE 6-162
1
2
FIGURE 6-163
1

Manitowoc Grove TMS9000-2 Series Specifications

General

Brand	Manitowoc
Model	Grove TMS9000-2 Series
Category	Construction Equipment
Language	English