16.2 FX List Editor (GT2104-R only)
16 - 29
GOT SELF CHECK (DEBUG)
16
16.2.11 Changing operands, set values
Changes the operand section of an applied instruction and OUT (T, C) command set value.
■1. Operation
*1 For decimal numbers, input K, then the number.
For hexadecimal numbers, input H, then the number.
POINT
POINT
Moving the cursor to the line on which the operand or set value is to be changed
When starting to change an operand or a set value, place the cursor on the line of the operand or
set value to be changed (the line on which the step number is not displayed).
If you place the cursor on the command line, the input operation is not possible.
■2. Example
Changing "MOV D0 D10" to "MOV D0 D123"
MODE SP
GO
(Read mode)
Stop the FX PLC
Input the device name and device number
D 1 2 3SP GO
MODE
3 MOV 12
D 0
D 10
8 LD M 10
3 MOV 12
D 0
D 123
8 LD M 10
< READ >
< WRITE >
Set the
WRITE
mode.
Stop the FX PLC
Move the cursor to the changed
location with or
To Next Page
Loading...
