Element Description
DYNAMIC (Knob 7) Amplifies or reduces the velocity derived from the pressure you apply
on each single pad you hold (Polyphonic Aftertouch). Available
values range from 1% to 200%. This setting applies globally to all
rate presets.
GATE (Knob 8) Adjusts the ratio between the duration of the notes and the duration
of the silences between them, measured as a percentage of the note
value set by RATE (see above). Available values range from 0% to
200%: At low values the notes are very short. At 50% notes and
silences are equal. At 100% (midcourse) each note last exactly until
the next note is triggered. At higher values notes overlap (provided
that the selected Sound is polyphonic). This setting applies globally
to all rate presets.
GATE RESET
(Button 4)
(same functionality as in previous MASCHINE versions)
Press this button at any time to reset the GATE parameter to its
default value 100%.
Arp mode seamlessly switches to Note Repeat mode as soon as you switch your pads
from Keyboard mode to Group mode (see above): All current values (including the LOCK
state) are retained.
To reproduce a Note Repeat using Arp mode, set TYPE to CHORD, SEQUENCE to Off,
and OCTAVES to 1. To repeat single notes, additionally make sure that chords are disa-
bled (in Pad Mode, check that Chord MODE is set to Off).
5.5.5 Swing Also Applied to Note Repeat / Arp Output
The Swing engines (at the Master, Group, and Sound level) process notes coming from the Pat-
tern Editor and from the Arp engine (pads in Keyboard mode) or Note Repeat engine (pads in
Group mode). In other terms, the swing is applied not only to your Patterns but also to any live
sequence generated by the Arp or Note Repeat engine.
Playing on Your Controller
Performance Features
MASCHINE STUDIO - Manual - 279
To Next Page
Loading...
Need help?
General
