Touch the Knob under a selector (here the MODE parameter under the left display) to open a list with the values available
for selection.
The list is displayed as long as you touch or turn the corresponding Knob. When you release
the Knob, the list disappears after a short delay.
Only one list can be displayed at a time. If you actuate two or more Knobs that control
selectors, only the list for the last-touched Knob will be shown.
2.6.8.2 List and Tag Overlays in the Browser
When browsing your Library from the MASCHINE STUDIO controller in Browse mode, the
touch-sensitive Knobs 1–8 provide you with handy browsing aids.
For general information on how to use the Browse mode of your controller to browse the
MASCHINE Library, please refer to section 3.2 “Searching and Loading Files from the
Library” in the MASCHINE 2.0 Manual.
Basic Concepts
Preferences
MASCHINE STUDIO - Manual - 99
To Next Page
Loading...
Need help?
General
