→
The focus slot can be selected from the browser.
6.1.3.2 Loading, Removing, and Replacing a Plug-in on your Controller
On the MASCHINE STUDIO controller, do the following:
1. At the top left of your controller, press the PLUG-IN button to enter Control mode and dis-
play the Plug-in slots of the selected Sound, Group or the Master.
2. Select the Sound, Group or the Master where the Plug-in is located (see section ↑2.3.1,
Setting the Focus on a Group or a Sound).
3. Press Button 5/6 to navigate to the desired Plug-in.
The name of the selected Plug-in appears in the field between the left and right arrows
under Button 5 and 6. If there are no Plug-ins in the channel this will read EMPTY.
→
You are now ready to load, insert, remove or replace a Plug-in as described in the follow-
ing paragraphs.
Loading a Plug-in in Place
To load a Plug-in into the selected Plug-in slot, do the following:
1. Press SHIFT + BROWSE to open the Plug-in Browser and browse the available Plug-ins.
2. On the left display, turn Knob 1 to select the TYPE from INTERNAL, NI or EXTERNAL.
The right display shows the list of available Internal, Native Instruments or External Plug-
ins, respectively.
3. If you have selected the first Plug-in slot of a Sound, turn Knob 2 to select the SUBTYPE
from Instr. (Instrument) or Effect.
If you have selected any other Plug-in slot the SUBTYPE field is not available — only Ef-
fect Plug-ins will be listed in the right display.
4. Turn the jog wheel or Knob 5 to browse the Plug-ins corresponding to your TYPE (and
possibly SUBTYPE) selection.
5. When you have found the Plug-in you want to use, press the jog wheel or Button 8 (LOAD)
to load it. You can also use Buttons 5 and 6 to step through the list and load each effect
directly.
Working with Plug-ins
Plug-in Overview
MASCHINE STUDIO - Manual - 298
To Next Page
Loading...
Need help?
General
