Main Page
Element Description
MAIN Section
Engine Selects the engine used in the Kick Plug-in. If you change this
setting, please refer to section 10.2 “The Kicks” in the
MASCHINE 2.0 Manual.
Tune Adjusts the pitch of the drum played by the middle C, measured in
MIDI note numbers and cents. Available values range from 31.00 to
55.00. The default value is 43.00.
Decay Adjusts the duration of the sound’s tail, measured as a percentage.
Available values range from 0.0 to 100.0% (default: 50.0%).
Bend Adjusts the amount of pitch envelope applied to the kick, measured
as a percentage. Available values range from 0.0 to 100.0%
(default: 6.8%).
Impact Adjusts the amount of click or initial attack, measured as a
percentage. Available values range from 0.0 to 100.0% (default:
75.0%).
Gate When enabled, the decay of the drum is choked by the end of the
note. When disabled, the drum plays as a one-shot sound, i.e. until
the end of its tail, no matter when the note is released, although the
sound duration will still depend on the Decay parameter (see
above). Switching Gate on and setting the Decay parameter to a
high value while playing short notes can result in a punchier, more
aggressive character than simply using short Decay values with Gate
off.
AERO Section
Using the Drumsynths
The Kicks
MASCHINE STUDIO - Manual - 553
To Next Page
Loading...
Need help?
General
