- 361 -
11. Utility Software
[Simple]: Connects to the LDAP server by Simple authentication.
[Digest-MD5]: Connects to the LDAP server by Digest-MD5 authentication.
[Secure Protocol]: Connects to the LDAP server by Secure Protocol (Kerberos)
authentication.
If you select [Anonymous], the machine always authenticates by Anonymous authentication. If you use the LDAP
server for the LDAP Name authentication, select an authentication method other than [Anonymous].
• If you select [Digest-MD5], you must set the DNS server.
• If you select [Secure Protocol], you must set SNTP server, DNS server, and secure protocol server.
14
If you select other than [Anonymous] in step 13, specify the user ID and
password to log in to the LDAP server.
15
Select the encryption method in [Encryption].
[None]: Encryption is not performed.
[LDAPS]: Encryption in LDAPS method is performed.
[STARTTLS]: Encryption in StartTLS method is performed.
16
Click [Submit].
You can set reception protocol (POP3, SMTP, etc.) so that the machine can receive e-mail.
1
Open the Web page of this machine.
Open the Web Page of This Machine
2
Log in as the administrator.
3
Select [Admin Setup].
4
Click [Network] > [Mail Server] on the left side of the screen.
5
Set the mail server based on the information on the setting information sheet if
necessary.
6
Click [Submit].
7
Click [E-mail] > [Receive Settings] on the left side of the screen.
8
Select [POP3] or [SMTP], and then click [To STEP2].
9
Set the POP3 protocol if necessary.
10
Click [Submit].
E-mail Setup
To Next Page
Loading...
Need help?
General
