132
EN
Shooting Settings
4
Shooting without shutter sound (Silents Settings)
PASMB
n
In situations where the shutter sound is a problem, you can use the silent shooting
modes to shoot without making a sound. An electronic shutter is used to reduce the
minuscule camera shake caused by the motion of the mechanical shutter, much as is
the case for anti-shock photography.
Menu
MENU n _ n7. Drive Mode n Silents Settings
Waiting Time
Choose how long the camera waits to begin shooting after the
shutter button is pressed all the way down when shooting in silent
shooting modes.
[0sec], [1/8sec], [1/4sec], [1/2sec], [1sec], [2sec], [4sec], [8sec],
[15sec], [30sec]
Noise Reduction
[O]: Shoots normally.
[Auto]: Reduces image “noise” in long exposures during silent
photography. The sound of the shutter may be audible when noise
reduction is active.
8
Choose whether to allow the beep to sound as specied (P. 251).
AF Illuminator
Choose whether to allow AF Illuminator to work as specied
(P. 96).
Flash Mode Choose whether the ash works as specied.
# During High Res Shot shooting (P. 156), [8], [AF Illuminator], and [Flash Mode] work in
[Allow] mode even if they are set to [Not Allow].
When [High Res Shot] is set to [Onn], however, [Flash Mode] is xed at [$Flash O].
• Be sure there is a check (v) next to a sequential shooting mode with ♥ in [Sequential
Shooting Settings] (P. 128).
• Select a mode with ♥ (P. 126), press the Q button, then take pictures. The monitor turns
dark for a short while when the shutter is released. The shutter does not sound.
# The desired results may not be achieved under ickering light sources such as uorescent
or LED lamps or if the subject moves abruptly during shooting.
# The fastest available shutter speed is 1/32000 s.
# The ash sync speed will be 1/50 s when [KISO] is 16000 or higher.
To Next Page
Loading...
Need help?
General
