30
EN
Preparation
1
Turning the camera on
1
Set the ON/OFF lever to the ON position.
• When the camera is turned on, the monitor will turn on and display the super control
panel (P. 69).
The viewnder turns on when you put your eye to the viewnder. When the viewnder
is lit up, the monitor turns o.
See P. 37 for information on how to switch between the viewnder and the monitor.
• To turn the camera o, return the lever to the OFF position.
ON/OFF lever
Monitor
ISO
ISO
1
1
[
1
:
02
:
03
[
1
:
02
:
03
]
10231023
PP
100
%
100
%
0.00.0
00
+
-
Battery level
The camera displays the level of the battery
currently in use. The battery level is shown as
percentages.
Level of current battery (%)
The indicator ashes red
when the level reaches 10%.
Viewnder
%The Fn lever can be congured to turn the camera on and o using the [Fn Lever/Power
Lever] option. g “Conguring [Fn Lever/Power Lever]” (P. 222)
Sleep Mode
If no controls are used for a set period, the camera will automatically enter suspend
operation to reduce the drain on the batteries. This is referred to as “sleep mode”.
• When the camera enters sleep mode, the monitor will turn o and operation will be
suspended. Pressing the shutter or q button reactivates the camera.
• If no operations are performed for a set period after the camera enters sleep mode, the
camera will turn o automatically. The camera can be reactivated by turning it on again.
# The camera may require additional time to recover from sleep mode when [On] (enabled)
is selected for [d Settings] > [Power-o Standby]. g “Wireless Settings for When the
Camera Is O (Power-o Standby)” (P. 263))
# The delay before the camera goes to sleep or turns o automatically can be selected in
the menu. g “Setting Sleep (Power Saving) Options (Sleep)” (P. 254), “Setting Auto
Power O Options (Auto Power O)” (P. 254)
To Next Page
Loading...
Need help?
General
