269
EN
Connecting the Camera to External Devices
8
Pairing the Computer with the Camera (New Link)
PASMB
n
The camera and computer must be paired in order to connect. Up to four computers
can be paired with the camera at a time. To pair a computer with the camera, connect it
via USB. Pairing need only be performed once per computer.
1
After conrming that the camera is o, connect it to the computer using the
USB cable.
• When attaching the USB cable, use the supplied cable protector and cable clip to
prevent damage to the connectors. g “Attaching Cable Protectors” (P. 19)
USB port
USB connector
USB cable (supplied)
• The locations of USB ports vary from computer to computer. See the documentation
provided with the computer for information on USB ports.
• If the USB port on the computer is Type A port, use the optional CB-USB11 cable.
2
Turn the camera on.
• The camera will display a message prompting you to identify the device to which the
USB cable is connected.
%If the message is not displayed, select [Select] for [USB Mode] (P. 252).
# If the batteries are very low, the camera will not display a message when connecting
to a computer. Be sure the batteries are charged.
3
Highlight [0RAW/Control] using FG on the
arrow pad and press the Q button.
USB
MTP
0
RAW/Control
USB PD
OK
Storage
Exit
4
Launch the copy of “OM Capture” installed on the
computer.
• After starting up, “OM Capture” will prompt you to
choose the connection type.
To Next Page
Loading...
Need help?
General
