To Next Page

To Previous Page

137

Shooting Settings

 Setting the detailed option of image stabilizer

When using lenses other than Micro Four Thirds or Four Thirds system lenses, input

the focal length of the lens.

Press the INFO button while conguring [KImage

Stabilizer] or [nImage Stabilizer]. Input the focal

length using FGHI and then press the Q

button.

0 0 0 9 0.

Image Stabilizer

Focal Length

Set the lens focal length. Input the number that is printed on the

lens.

[0.1] – [1000.0] mm

# Image stabilization may be unable to compensate for excessive camera motion or very

slow shutter speeds. Use a tripod in these cases.

# You may notice noise or vibration while image stabilization is in e󰀨ect.

# The setting selected with the lens image stabilization switch, if any, takes priority over that

selected with the camera. This can be changed. g “Image Stabilization for IS Lenses

(Lens I.S. Priority)” (P. 139)

# [S-IS Auto] functions as [S-IS1] when [On] is selected for [Lens I.S. Priority] (P. 139).

# When you select [S-IS Auto] or [S-IS1] with ♥jSH2/ProCap SH2 selected as the drive

mode (P. 126), the image stabilization will be suitable for camera moves in the depth

direction, compared to when used with other sequential shooting modes.

%You can choose whether image stabilization will be performed while the shutter button is

pressed halfway. g “Half-press image stabilization (aImage Stabilizer)” (P. 138)

%The selected value is not reset when you select [Reset Shooting Settings] in [Reset/

Initialize Settings] (“Restoring Default Settings (Reset/Initialize Settings)” (P. 257)).

Image stabilization options (nIS Level)

PASMB

Choose the amount of image stabilization applied during movie recording.

MENU n n n4. Image Stabilizer n nIS Level

+1 Choose for static hand-held shots.

±0 Recommended in most situations.

–1 Choose for hand-held panning, tilting, or tracking shots.

Olympus OM System OM-1 User Manual

Questions and Answers: