3.42
ENGINE / COOLING
9924096 - 2013 RANGER RZR XP 900 / RZR XP 4 900 Service Manual
© Copyright 2012 Polaris Sales Inc.
ENGINE DISASSEMBLY / INSPECTION - LOWER END
Stator Cover Removal / Inspection
NOTE: The stator cover can be removed with the
engine installed in the chassis.
1. Remove the (13) screws retaining the stator cover.
2. Carefully pry the stator cover off the engine using the
two pry areas as shown below.
3. Inspect the condition of the stator windings (A) and
output wires (B). If replacement is required, refer to
Chapter 10.
4. Inspect the ball bearing (C) that supports the starter
motor shaft.
5. If bearing replacement is required, remove the
retaining ring and heat the stator cover around the
bearing evenly with a heat gun. Tap cover on a soft
work surface to remove the bearing from the housing.
A blind bearing puller can also be used. Replace
bearing if removed.
The flywheel contains powerful magnets. Use
caution when removing and installing the stator
cover. DO NOT place fingers between cover and
crankcase at any time during the removal /
installation process or injury could result.
To Next Page
Loading...
Need help?
General
