2.36
MAINTENANCE
9924096 - 2013 RANGER RZR XP 900 / RZR XP 4 900 Service Manual
© Copyright 2012 Polaris Sales Inc.
Engine / Chassis Electrical Ground
Inspect the ground cable connections. Remove ground
terminals and clean if necessary.
RZR XP
1. Remove the driver’s seat and locate the start
solenoid (A) behind the battery box.
2. Inspect the ground terminals (B) located below the
solenoid. Be sure they are clean and tight.
RZR XP 4
1. Remove the left rear passenger seat and the engine
service panel to access the ground terminals (B).
2. Inspect the ground terminals. Be sure they are clean
and tight.
Spark Plug Service
Inspect and replace the spark plugs at the intervals
outlined in the Periodic Maintenance Chart.
1. Remove the cargo box access panel (A).
2. Remove both spark plug caps (B).
IMPORTANT: Note MAG and PTO reference decals (C)
on spark plug wires for reassembly.
3. Clean out plug wells with compressed air to remove
any loose dirt or debris.
4. Rinse plug wells with water and dry with compressed
air.
NOTE: Spark plug wells have drain holes built into
the cylinder head to allow water to drain out.
A hot engine can cause serious burns. Allow
engine to cool or wear protective gloves when
removing the spark plugs.
To Next Page
Loading...
Need help?
General
