5.40
BODY / STEERING / SUSPENSION
9924096 - 2013 RANGER RZR XP 900 / RZR XP 4 900 Service Manual
© Copyright 2012 Polaris Sales Inc.
FRONT STABILIZER BAR (INT’L)
Stabilizer Bar Linkage Removal / Installation
1. Elevate and safely support the front of the vehicle.
2. Remove the lower linkage mounting fastener from the
upper A-arm on each side of the vehicle (see
“Exploded View”).
3. Remove the linkage mounting fasteners that attach
the upper portion of each linkage to the stabilizer bar
clamps. Remove the linkages from the vehicle (see
“Exploded View”).
4. Inspect the linkage assemblies for signs of excessive
wear or damage. Replace linkage assembly if
damaged.
5. Reverse this procedure for installation. Torque the
linkage fasteners to specification (see “Exploded
View”).
Stabilizer Bar Removal / Installation
1. If stabilizer bar linkages are installed, remove the
bolts that attach the upper portion of the linkages to
the stabilizer bar clamps. Only remove clamps if
replacing stabilizer bar.
2. Remove the (2) fasteners on each side of the vehicle
retaining the front stabilizer bar to the frame.
3. Lift up on the stabilizer bar to free it from the mount
bracket. Remove the stabilizer bar and bushings from
the vehicle.
4. Inspect the stabilizer bar for straightness. Inspect the
bushings and replace if needed.
5. Reverse this procedure for installation. Torque the
linkage fasteners to specification (see “Exploded
View”).
6. If the clamp was removed from stabilizer bar, refer to
the following image for installation reference. The
clamps should be flush with the end of the stabilizer
bar.
To Next Page
Loading...
Need help?
General
