10.21
ELECTRICAL
10
9924096 - 2013 RANGER RZR XP 900 / RZR XP 4 900 Service Manual
© Copyright 2012 Polaris Sales Inc.
3. Carefully lift and remove headlamp assembly from the
bumper.
Headlamp Installation
1. Install the headlamp adjustment springs onto the
front bumper mounting bosses.
2. Insert the (3) T-25 headlamp mounting screws into the
headlamp assembly mounting holes.
3. Maneuver the headlamp assembly into position. Be
sure all (3) headlamp springs and mounting screws
are properly aligned with mounting bosses on the front
bumper.
4. Fully tighten all (3) headlamp screws until the
headlamp assembly is fully seated. Back headlamp
mounting screws off 1/8” to 1/4” (2-3 turns).
5. Install the front bumper as shown in Chapter 5 if
previously removed.
6. Connect headlamp electrical connector to the
headlamp assembly.
7. Perform the “Headlight Adjustment” procedure as
shown in this chapter.
TAIL / BRAKE LIGHTS
Bulb Replacement
Before replacing the bulb(s), use a digital multi-meter to
test the harness to ensure the lamp is receiving 12 volts
and that a ground path is present.
If a tail light, brake light or turn signal (INT’L Only) does not
work the bulb may need to be replaced.
1. Disconnect the wire harness.
2. Remove bulb by turning the rubber base 1/4 turn and
pulling the bulb out. Replace it with recommended
bulb. Apply Dielectric Grease (PN 2871329).
3. Test the tail light, brake light and turn signal (INT’L
Only) to verify it is working properly.
Tail / Brake
Light
Turn Signal
Light
INT’L
Models
To Next Page
Loading...
Need help?
General
