10.8
ELECTRICAL
9924096 - 2013 RANGER RZR XP 900 / RZR XP 4 900 Service Manual
© Copyright 2012 Polaris Sales Inc.
Under / Over Voltage
This warning usually indicates that the vehicle is operating
at an RPM too low to keep the battery charged. It may also
occur when the engine is at idle and a high electrical load
is applied (lights, cooling fan or other accessories).
If battery voltage drops below 11 volts, a warning screen
will display “Lo” and provide the present battery voltage. If
voltage drops below 8.5 volts, LCD backlighting and icons
will turn off.
If battery voltage rises above 15 volts, a warning screen
will display “OV” and provide the present battery voltage.
If voltage rises above 16.5 volts, LCD backlighting and
icons will turn off.
Park Brake Indicator (INT’L Model Only)
This warning is used to notify the operator that the park
brake lever is engaged.
When the park brake is fully engaged, “BRAKE” appears
in the rider information display. Engine speed is limited to
1500 RPM in all gears, except neutral. If throttle is applied,
this limiting feature prevents operation, which protects the
park brake pads from excessive wear.
Diagnostic Mode
The diagnostic mode is accessible only when the check
engine MIL has been activated.
Use the following procedure to display diagnostic trouble
codes that were activated during current ignition cycle
causing the MIL to illuminate. Diagnostic trouble codes will
remain stored in the gauge (even if MIL turns off) until the
key is turned off.
1. If the trouble code(s) are not displayed, use the
MODE button to toggle until “CK ENG” displays on
the information display area.
2. Press and hold the MODE button to enter the
diagnostics code menu.
To Next Page
Loading...
Need help?
General
