6.21
CLUTCHING (PVT)
6
9924096 - 2013 RANGER RZR XP 900 / RZR XP 4 900 Service Manual
© Copyright 2012 Polaris Sales Inc.
DRIVEN CLUTCH SERVICE
Clutch Disassembly
1. Remove driven clutch from the transmission input
shaft. Do not attempt disassembly of the driven clutch
from the outside snap ring. The driven clutch must be
disassembled from the helix side.
2. It is important to mark the position of the shaft, cam
cover and sheave before disassembly or use the X’s
on the components for reference. This will aid in
assembly and maintains clutch balance.
3. Remove the four screws that secure the cam (helix)
assembly using a T25 Torx driver.
4. Place the driven clutch into the Universal Clutch
Compressor PU-50518.
5. Press down on the top of the spider assembly,
pushing the spider onto the shaft. Remove snap ring
(A) and slowly release the assembly.
Do not disassemble from this side
To Next Page
Loading...
Need help?
General
