10.20
ELECTRICAL
9924096 - 2013 RANGER RZR XP 900 / RZR XP 4 900 Service Manual
© Copyright 2012 Polaris Sales Inc.
HEAD LIGHTS
Headlight Adjustment
The headlight beams are adjustable.
1. Place the vehicle on a level surface with the headlight
approximately 25 ft. (7.6 m) from a wall.
2. Measure the distance from the floor to the center of
the headlight and make a mark on the wall at the same
height.
3. With the machine in Park, start the engine and turn the
headlight switch to the LOW position.
4. The most intense part of the LOW beam headlight
beam should be aimed 2 in. (5 cm) below the mark
placed on the wall in Step 2.
NOTE: Rider weight must be included in the seat
while performing this procedure.
5. Adjust the beam to the desired position by loosening
or tightening the (3) T-25 adjustment screws and
moving the lamp to the appropriate height.
6. Adjust the beam to desired position. Repeat the
procedure to adjust the other headlight.
Headlamp Replacement
IMPORTANT: If an LED headlamp has fogging or
moisture inside, disconnect the wire harness from the
headlamp(s) for a few days to allow the moisture to
clear out.
1. Disconnect wire harness from headlamp assembly.
Be sure to pull on the connector, not on the wiring.
2. Remove the (3) T-25 headlamp mounting screws and
(3) adjustment preload springs.
NOTE: The front bumper can be removed and
placed face down on a suitable workbench to ease
headlamp replacement (see Chapter 5).
Due to the nature of light utility vehicles and
where they are operated, headlight lenses
become dirty. Frequent washing is necessary to
maintain lighting quality. Riding with poor
lighting can result in severe injury or death.
To Next Page
Loading...
Need help?
General
