7.27
FINAL DRIVE
7
9924096 - 2013 RANGER RZR XP 900 / RZR XP 4 900 Service Manual
© Copyright 2012 Polaris Sales Inc.
6. Connect the AWD wire harness.
7. Refer to “FRONT DRIVE SHAFT - Drive Shaft
Installation” and install both front drive shafts into the
gearcase.
8. Add the proper lubricant to the front gearcase. Refer
to Chapter 2 for fluid fill and change information.
REAR BEARING CARRIER
Bearing Carrier Inspection / Removal
1. Elevate rear of vehicle and safely support machine
under the frame area.
2. Check bearings for side play by grasping the top and
bottom of the tire firmly and checking for movement.
The tire should rotate smoothly without binding or
rough spots.
3. Remove the (4) wheel nuts and rear wheel.
4. Remove the cotter pin and loosen the rear wheel hub
castle nut. Remove the nut, and (2) cone washers
from the rear wheel hub assembly.
5. Remove the lower radius rod outer mounting bolt, nut
and washer from the bearing carrier. Swing radius rod
down. Discard the nut.
Recommended Front Gearcase Fluid:
Polaris Demand Drive Plus
(PN 2877922) (Quart)
Capacity: 6.75 oz. (200 ml)
Serious injury may result if machine tips or falls.
Be sure machine is secure before beginning this
service procedure. Wear eye protection when
removing bearings and seals.
Castle Nut
Cotter Pin
Cone
Washers
To Next Page
Loading...
Need help?
General
