4.38
ELECTRONIC FUEL INJECTION
9924096 - 2013 RANGER RZR XP 900 / RZR XP 4 900 Service Manual
© Copyright 2012 Polaris Sales Inc.
ECU Output Supply Voltage 2
Voltage Too High
3598
3 P16A9
Voltage Too Low 4 P16A8
ECU Output Supply Voltage 3
Voltage Too High
3599
3 P17AA
Voltage Too Low 4 P17AB
Throttle Release Signal
Voltage Too High
520194
3 P1555
Signal Out of Range 2 P1553
Throttle Stuck 7 P1552
All Wheel Drive Control Circuit
(AWD)
Driver Circuit Open / Grounded
520207
5 P1836
Driver Circuit Short to B+ 3 P1835
Driver Circuit Grounded 4 P1834
Steering Over Current Shut Down Current Above Normal or Grounded 520221 6 C1050
Steering Excessive Current Error Current Above Normal or Grounded 520222 6 C1051
Steering Torque Partial Failure Condition Exists 520223 31 C1052
Steering Torque Full Failure Condition Exists 520224 31 C1053
EPS Inverter Temperature
Greater than 110° C (230° F)
520225
16 C1054
Greater than 120° C (248° F) 0 C1055
EPS CAN Communications
Receive Error
No RX Message for 2 Seconds 520226 2 U0100
EPS CAN Communications
Transmit Error
No TX Message for 2 Seconds 520227 2 U1100
Position Encoder Error Position Encoder Error 520228 11 C1065
EPS Software Error Software Error 520229 12 C1070
IC CAN Communication with EPS EPS Off Line (EPS DM1 not seen) 520230 31 U0131
EPS Power Save Condition
EPS: Key On, Engine Off, 5 Minute
Power Save/Timeout
520231 31 C1071
Idle Air Control Valve (IAC)
M17; IAC Stepper Pin 3
Driver Circuit Open / Grounded
520268
5 P1515
Driver Circuit Short to B+ 3 P1519
Driver Circuit Grounded 4 P1518
Idle Air Control Valve (IAC)
M17; IAC Stepper Pin 4
Driver Circuit Open / Grounded
520269
5 P1525
Driver Circuit Short to B+ 3 P1529
Driver Circuit Grounded 4 P1528
Idle Air Control Valve (IAC)
M17; IAC Stepper Pin 6
Driver Circuit Open / Grounded
520270
5 P1535
Driver Circuit Short to B+ 3 P1539
Driver Circuit Grounded 4 P1538
Idle Air Control Valve (IAC)
M17; IAC Stepper Pin 1
Driver Circuit Open / Grounded
520271
5 P1505
Driver Circuit Short to B+ 3 P1509
Driver Circuit Grounded 4 P1508
Component Condition SPN FMI
Digital Wrench®
P-Code