5.58
BODY / STEERING / SUSPENSION
9924096 - 2013 RANGER RZR XP 900 / RZR XP 4 900 Service Manual
© Copyright 2012 Polaris Sales Inc.
39. Remove oil residue from above the IFP with a clean
shop towel.
40. Lubricate and install a new pellet into the reservoir
cap.
41. Install the pellet retainer.
42. Lubricate the reservoir cap O-ring.
43. Install and depress the reservoir cap past the retaining
ring groove.
44. Install the reservoir cap retaining ring.
45. Use the nitrogen charging needle (7052069-A) and
safely charge the reservoir to the recommended
pressure.
46. Stroke the shock through its travel and adjust the
external adjusters to ensure they are functioning
properly
.
47. Use a rubber mallet to fully seat the bearing cap into
position.
48. Use a dead blow hammer to fully seat a new nylon ball
into the reservoir cap.
49. Install suspension spring(s) and reset preload to
factory settings.
50. Adjust external adjusters to the factory settings
51. Install shock onto the vehicle and torque fasteners to
specification.
CHARGE THE SHOCK USING NITROGEN
GAS ONLY. DO NOT FILL WITH ANY OTHER
GASES. Doing so compromises the
performance of the shock and may be
EXTREMELY DANGEROUS!
Nitrogen Pressure (Front and Rear):
200 psi (1379 kPa) +/- 5%
To Next Page
Loading...
Need help?
General
