5.66
BODY / STEERING / SUSPENSION
9924096 - 2013 RANGER RZR XP 900 / RZR XP 4 900 Service Manual
© Copyright 2012 Polaris Sales Inc.
IMPORTANT: Keep the rebound and compression
valve stacks in the order they were removed. If unsure
of order, refer to “Shock Valving” under the “Shock
Service Information” provided earlier in this section.
15. Place the valve stack on a clean shop towel in order
of removal.
16. Inspect the valves for kinks, waves, pits or foreign
material.
17. Inspect the piston wear band and replace if damaged
or worn.
18. Use the appropriate shock body holding tool to
properly secure the shock assembly into a vice for
service.
19. Front Shocks Only: Using a 9/16" socket w/
extension, remove the fastener retaining the clicker
valve stack. Place the valve stack on a clean shop
towel in order of removal.
IMPORTANT: Keep the valve stack in the order it was
removed. If unsure of order, refer to “Shock Valving”
under the “Shock Service Information” provided
earlier in this section.
20. Inspect the valves for kinks, waves, pits or foreign
material
21. Thoroughly clean all shock components and shock
body prior to assembly.
Front Shock Body Holding Tool: PU-50979
Rear Shock Body Holding Tool: PU-50938
Rebound side
of piston
Compression
valve stack
To Next Page
Loading...
Need help?
General
