Polaris xp 2013 eps User Manual

7.5
FINAL DRIVE
7
9924096 - 2013 RANGER RZR XP 900 / RZR XP 4 900 Service Manual
© Copyright 2012 Polaris Sales Inc.
7. Install the steering tie rod end onto the front bearing
carrier.
NOTE: Refer to the photos below to ensure proper
placement of the tie rod end.
8. Torque the tie rod end fastener to specification and
install a new cotter pin.
9. Torque wheel hub nut to specification and install a
new cotter pin. Tighten nut slightly if necessary to
align cotter pin holes. Bend both ends of cotter pin
around end of spindle in different directions.
10. Install wheel and (4) wheel nuts. Torque wheel nuts
to specification.
11. Rotate wheel and check for smooth operation.
CAUTION
New bolts have a pre-applied locking agent
which is destroyed upon removal. Always use
new brake caliper mounting bolts
upon assembly.
= T
Tie Rod End Fastener:
42.5 ft-lbs (58 Nm)
Tie Rod End
42.5 ft-lbs
58 (Nm)
= T
Wheel Hub Castle Nut:
80 ft-lbs (108 Nm)
= T
Wheel Nuts:
30 ft-lbs (41 Nm) + 90° (1/4 turn)
80 ft-lbs
(108 Nm)
NEW Cotter Pin

Polaris xp 2013 eps Specifications

General

Brand	Polaris
Model	xp 2013 eps
Category	Utility Vehicle
Language	English