2.22
MAINTENANCE
9924096 - 2013 RANGER RZR XP 900 / RZR XP 4 900 Service Manual
© Copyright 2012 Polaris Sales Inc.
15. Remove the cross member from the vehicle to gain
access to valve cover as shown below.
16. Remove the (4) T40 bolts retaining the valve cover.
17. The engine will need to be rotated (4) times to inspect
all (8) valve clearances. Two valves can be measured
at each camshaft lobe position.
NOTE: Remove spark plugs to aid engine rotation.
18. Rotate the drive clutch counter-clockwise until the
cam lobes above the valves you are inspecting are
facing up.
19. Measure the valve clearance using a feeler gauge.
20. If the valve clearance is out of specification, proceed
to “Valve Clearance Adjustment” (see Chapter 3).
21. Repeat steps 18-20 until all (8) valves have been
inspected.
MAG
Intake
PTO
Intake
MAG
Exhaust
PTO
Exhaust
Intake Valve Clearance (cold):
.006 ± .002 in. (0.15 ± 0.05 mm)
Exhaust Valve Clearance (cold):
.012 ± .002 in. (0.30 ± 0.05 mm)
To Next Page
Loading...
Need help?
General
