3.24
ENGINE / COOLING
9924096 - 2013 RANGER RZR XP 900 / RZR XP 4 900 Service Manual
© Copyright 2012 Polaris Sales Inc.
9. Remove lower mounting bolt (A) from the left rear
shock and discard the nut. Install a new nut upon
assembly.
10. Remove the outer clutch cover screws (B) and remove
the cover from the vehicle.
11. Remove drive belt, drive clutch, driven clutch, inner
clutch cover and clutch outlet duct (see Chapter 6).
IMPORTANT: Be sure to use the correct Drive Clutch
Puller (PN 2872085) to prevent damage to crankshaft.
12. Disconnect the IAC valve (C), MAQS (D), ECT sensor
(E), and CPS sensor (F) connectors, fuel injector
harness leads (G) and ignition coil harness lead.
Remove wire ties retaining harness to the fuel rail and
rear cross member.
13. Disconnect the stator harness (H).
14. Remove (+) positive cable from the starter motor.
15. Remove (-) negative cable from the starter mounting
bolt.
Correct Drive Clutch Puller P/N 2872085
To Next Page
Loading...
Need help?
General
