How to Use the Feeder
Tacking a stack of mail:
1. Arrange the mails according to size (largest and heaviest on the bottom).
2. Fan out the envelopes to ensure separation (envelopes may be stuck together).
3. Bevel the edge of the stack.
4. Place the envelopes on the hopper against the rear wall and covering the optical
(clear) sensor. Ensure that all envelopes in the stack are against the rear wall.
Ensure that all the envelopes are stacked along the rear guide, from largest to
smallest.
Nested envelope flaps: insert the flaps into the slot at the rear
guide of the envelope hopper.
Do not try to seal self-adhesive envelopes. Close them before
feeding.
3
Meet Your Mailing System
19
| Page 19 | Jan-15-2024 09:55 |
To Next Page
Loading...
Need help?
General
