Quantum Scalar i6000 User Manual

Chapter 3: Configuring Your Library
Setting Up Policies for the Physical Library
180 Quantum Scalar i6000 User’s Guide
Note: If the target port state is offline, the port's connection has not
been repaired. The error condition that caused the port to fail
still exists.
On the FC Host Port Failover dialog box, click the Physical Ports
tab. The dialog box shows you each target port on the I/O blade, the
port’s state, and the type of failure that has occurred, if applicable.
11 Click the port you want to enable.
12 Click Enable.
Note: Enable is available only if the port is disabled.
13 To return to the main FC Host Port Failover dialog box, click Close.
Setting Up Policies for the Physical Library
The Physical Library dialog box enables you to configure various
operating modes:

Quantum Scalar i6000 Specifications

General

Form Factor	Rack-mountable
Interface	Fibre Channel, SAS
Product Type	Tape Library
Cooling	Redundant cooling fans
Dimensions	Varies by configuration
Weight	Varies by configuration
Operating Humidity	20% to 80% non-condensing
Scalability	Scalable
Drive Types	LTO
Redundancy	Redundant power supplies
Management	Web-based management
Tape Technology	LTO
Supported Media	LTO Ultrium 9, LTO Ultrium 8, LTO Ultrium 7, LTO Ultrium 6
Power Supply	Redundant power supplies
Non-operating Humidity	5% to 95% non-condensing