Chapter 15: Maintaining Your Library
Maintenance Actions
Quantum Scalar i6000 User’s Guide 599
5 Click Start. A message Updating do not power cycle the drive is
displayed above the drive table in red. The Status column in the
drive table displays the status of the update.
Caution: The drive firmware image must be compatible with the
drives that you will update with it. For more
information, see the Customer Service Web site.
Teaching the Library
(Configuration and
Calibration)
The Te a ch command enables you to update the library’s stored
configuration and calibration information. Use this command after you
replace a library component or whenever you need to assess the
library’s physical configuration (such as the number of modules and I/E
stations, the locations of storage magazines and drives, and the types of
media used in the library) or the position and alignment of library
components.
Running Configuration Teach
Starting the configuration teach process causes the library to assess its
contents, gathering information as follows:
• Number of modules
•Types of media
• Storage magazine locations
• Number of I/E stations and magazine type
•Types of drives
• Drive locations
If you change the library’s physical configuration in any of these areas,
you should initiate the configuration teach process (for example, when
you add or remove storage or remove storage to add another
component. The library will automatically perform a configuration
teach, calibration teach, and inventory when an expansion module is
added.
To Next Page
Loading...
Need help?
General