Quantum Scalar i6000 User Manual

Chapter 3: Configuring Your Library
Configuring Library Security
240 Quantum Scalar i6000 User’s Guide
Configuring Access for
SNMP and SMI-S
The SNMP/SMI-S tab on the Security Configuration dialog box allows
you to enable or prevent SNMP or SMI-S traffic across the MCB Ethernet
port.
1 Click the SNMP/SMI-S tab on the Security Configuration dialog
box.
2 You can change the security settings for any of the following items:
• SMI-S — To allow SMI-S traffic (port 5988), select the Enable
SMI-S check box. To allow encryption of SMI-S traffic (SSL, port
5989), select the Enable Secure SMI-S check box.
Note: Port 427 is used for Service Location Protocol (SLP),
which is used along with the Common Information
Model (CIM) server.
• SNMP — To prevent all SNMP traffic across the MCB Ethernet
port, select Disable. To allow SNMP Get operations, select
Enable.
If SNMP traffic is allowed, then SNMP v3 is always available. If
you want to permit less secure SNMP access, select Enable
SNMP v1 and v2. If you decide you do not want to use SNMP
v1 and v2, clear the Enable SNMP v1 and v2 check box.

Quantum Scalar i6000 Specifications

General

Brand	Quantum
Model	Scalar i6000
Category	Storage
Language	English