8-30 Accessories
Placing the unwinder for inside wound labels
Media Loading
The mounting steps depend on the cardboard core of the chosen material roll.
Possible cardboard cores are 1.56 in (40 mm) and 3 in (76 mm). At first you
have to prepare the flanges and the winding axle in dependence to the
cardboard core.
Preparing the Winding Axle and the Flanges
There is a spring (8) mounted on the winding axle (2) to guarantee proper
stability of the unwinding material when using rolls with a 1.56 in (40 mm)
cardboard core.
When unwinding from rolls with a 3 in (76 mm) cardboard core this spring
has to be removed. For this you have to loosen the two screws (9).
Preparing the winding axle
When using material rolls with 3 in (76 mm) cardboard core a winding
adapter (4) has to be fixed on each of the two flanges (3) for proper stability of
To Next Page
Loading...
Need help?
General
